Skip to content

Wiggle settings ​

The default settings are ready to use. To change the wiggle, edit these materials:

text
Assets/TpLab/WigglePen/Materials/WiggleInk_PC.mat
Assets/TpLab/WigglePen/Materials/WiggleInk_Quest.mat

Wiggle properties ​

Select a material in the Project window and adjust its values in the Inspector.

PropertyDefaultDescription
Wiggle Amplitude (m)0.006 (6 mm)Amount of wiggle. Set to 0 for no wiggle
Wiggle Detail (cells/m)24How fine the wiggle pattern is
Wiggle Frame Rate (fps)8How often the line shape updates
Near Clip Distance0.1Hides lines closer to the camera than this distance
Far Clip Distance100Hides lines farther from the camera than this distance

Reduce the wiggle ​

Lower Wiggle Amplitude (m). For example, 0.003 is 3 mm. If you also change Detail or Frame Rate, change one property at a time to compare the results.

Change the update frequency ​

Lower Wiggle Frame Rate (fps) to increase the interval between changes in the line's shape. At 0, the line keeps its deformed shape but stops moving. To remove the deformation as well, set Amplitude to 0.

Line width ​

QvPen applies each pen's Ink Width when drawing. Changing only Width on the PC material has no effect because QvPen overwrites it. To change the line width, find the target pen inside the prefab and adjust Ink Width on its QvPen Pen Manager component. The unit is meters.

PC and Quest ​

PC and Quest use separate materials. To use the same wiggle settings on both, edit both materials.

The PC material uses the TpLab/WiggleInk/rounded_trail shader; the Quest material uses TpLab/WiggleInk/Quest. The prefab already has references to both. Do not replace the Quest material reference with the PC material.

Shared materials

Changes affect every pen using the same material. After adjusting the settings, build for the target platform and check the appearance.

WigglePen / WigglePenAvatar Documentation