Skip to content

Fingertip placement ​

When you place the prefab directly under the avatar root, the index fingertip is detected automatically. Adjust the offset if the pen tip is inside the finger or too far away from it.

Adjust the values ​

  1. Exit Play mode.
  2. Select WigglePen_Right or WigglePen_Left in the Hierarchy.
  3. Open Avatar Pen Auto Placement in the Inspector.
  4. Adjust 指先オフセット XYZ (m) (Fingertip offset XYZ, in meters).
  5. Check the position in the Scene view and save the scene.

The unit is meters. To move the tip by about 1 mm, start with a small change of 0.001. XYZ uses the index finger's distal bone local coordinates, so the axis pointing toward the fingertip depends on the avatar.

Adjust in the Scene view ​

With the same prefab selected, a move handle appears at the pen tip. Dragging it also updates the XYZ offset values.

  • Local: Move along the finger bone's axes.
  • Global: Move along the world axes.

The saved XYZ values always use the distal bone's local coordinates. If the handle is missing, enable Gizmos in the Scene view.

Inspector fields ​

Japanese field names are shown as they appear in the Inspector.

FieldDescription
Hand AnchorThe MA Bone Proxy specifying the hand. Normally no change is needed
Pen TipThe pen tip to place automatically. Normally no change is needed
対象 (Target)The detected index finger distal bone
位置の算出方法 (Position calculation method)Uses an End bone, skinned vertices, or an estimate based on joint spacing
末端ボーン基準 (Relative to distal bone)The calculated local position

Save your changes ​

Placement updates in Edit mode. It is not recalculated during the build, so save the scene after making adjustments. If you are testing with Gesture Manager, exit Play mode before adjusting, then enter Play mode again.

WigglePen / WigglePenAvatar Documentation